Introduction to the characteristics of each type of Uv Accelerated Weathering Te

Uv Accelerated Weathering Tester is currently used more aging test model besides xenon lamp aging test box. The aging test experiment of materials currently has different requirements for different conditions. The engineers of Standard Group (Hong Kong) Co., Ltd. will provide you a simple Introduce the characteristics of each type of Uv Accelerated Weathering Tester.

 

Uv/se type Accelerated Weathering Tester

The Uv/se Accelerated Weathering Tester is the most popular Uv model. Its main performance feature is that it is equipped with a solar eye intensity control system that can accurately control the UV light intensity. Uv/se also uses the proven principle of condensation to simulate the impact of bad moisture on product performance. Uv/seAccelerated Weathering Tester also provides a fast, high online rate test. It is a standard way to ensure longer lamp life and meet ISO requirements. Although Uv/se is an artistic and ultraviolet accelerated aging test box in design, it is a cheap, easy-to-use test box.

 

Uv/basic Accelerated Weathering Tester

The Uv/basic Accelerated Weathering Tester is a simplified version of Uv. It is suitable for laboratories with limited economic conditions. The Uvbasic Accelerated Weathering Tester is equipped with a condensation system to simulate the influence of moisture, but it is not equipped with a water spray function.

Uv/basic type, through a simple lamp cycle and replacement method to compensate for the loss caused by the aging of the lamp, this is designed to replace the longest 2 of the 8 lamps after the lamp runs every 400 hours. This mode of operation ensures that the service life of each lamp tube is 1600 hours. At the same time, it also ensures that at any time, the output power of Uv always remains on the output curve during the life, the average value of 4 different points. This average value always remains relatively stable and does not change over time. With this lamp replacement mode, the maintenance of the lamp only needs to be carried out every 4-6 weeks according to the degree of selection of the UV/condensation cycle, and the maintenance process of the lamp only takes about 5 minutes.

Since the Uv/normal type is not equipped with a solar eye light intensity control system, the light intensity cannot be adjusted or calibrated. Because Uv/basic cannot compensate for light intensity, we recommend that you choose this model only when conducting exposure comparison tests.

 

Uv/spray type Accelerated Weathering Tester

UvsprayAccelerated Weathering Tester has the same standard as Uv/se, but it is equipped with a water spray bear on the basis of Uv/se and he will give it to you. The water spray system is composed of 12 nozzles and joint pipe fittings, a control system and a drain pipe.

Uv/sparyAccelerated Weathering Tester can choose to set the following cycles according to needs: UV cycle, spray cycle or condensation cycle, short-term spray can be used to simulate the effect of temperature fusion, long-term spray can be used to simulate the machinery caused by rain erosion erosion. For best results, it is recommended to spray with deionized water in most cases.

 

More about Uv Accelerated Weathering Tester: http://www.standard-groups.com/en/Weathering/758.html