Universal Testing Machine oil change need to pay attention to the 14 matters

Universal Testing Machine is a kind of instrument used for tensile testing, the maximum load is 10KN.

 

 

1, the tester is the oil cylinder up or cylinder down type?

2, the equipment is with microcomputer control (such as: microcomputer control of electronic universal testing machine (floor type))?

3, or digital display screen (such as: WE-B series of digital display hydraulic universal testing machine) of the reading?

4, the digital display and computerized oil source is generally similar.

5, if the tension machine control system is to read the disk (that is, the value through a dial of the kind of degrees called dial type) then the oil change trouble;

6, the oil source can not move.

7, in the side of the oil source an oil release port, find a shorter container;

8, little by little, pay attention is not to move the oil source behind the weight and the location of the internal stuff.

9, if it is under the type of then it is simple.

10, put the oil: the pipe what do not move;

11, there is an oil tank behind the oil drain, the tensile testing machine control cabinet raised;

12, open the oil discharge port, oil discharge; raise the control cabinet when the attention of the computer line and so on;

13, if inconvenient, the need to remove the pipe, line and so on, remove the mark before you must do a good job;

14, to avoid the occurrence of incorrect wiring.

 

Refueling.

 

1, the control cabinet down the original position, if the removal of the tube;

2, to be connected to the tube before refueling, there is a refueling port above the tank;

3, because there is a filter inside, so the refueling speed will be very slow;

4, if you add the oil clean, you can remove that strainer.