NewsInformation Center
Do You Kown How To Measure The Zipper Gauge Correctly?
2023/05/19
Share:
Zipper gauge refers to the width of the zipper teeth. It is measured in millimeters or inches. The wider the tooth width, the stronger the transverse chain. The larger the zipper gauge, the stronger the zipper and the heavier or thicker the fabric that is sewn onto it, no matter which type it is classified as.
Measuring the size of a zipper can be done in the following steps:
1. Measuring the length:
Open the zipper and place it flat on a horizontal surface. Use a ruler or measuring tape to measure the full length of the zipper, which is the total length from the top to the bottom of the zipper. Measurements are usually taken in centimeters or inches.
2. Measuring tooth size:
Use a ruler or caliper to measure the size of the zipper teeth. Align one side of the measuring tool with the top of one tooth and read the distance from the top to the bottom. Measurements are usually taken in millimeters or inches. Be sure to select a typical tooth to measure to get an accurate tooth size.
3. Measuring Width:
Measuring the width of a zipper refers to the width of the zipper tape on both sides of the zipper. Use a ruler or measuring tape to measure the width of the zipper tape on both sides of the zipper, usually in millimeters or inches.
4. Measuring the number of teeth:
Open the zipper completely and measure the number of zipper teeth using the eye-view method or by counting manually. Usually, the number of teeth is an important parameter for zipper sizing.
Please note that when measuring zipper size, try to keep the zipper in a flat and relaxed state to get accurate measurement results. In addition, depending on the specific zipper type and application, other specific dimensional parameters may need to be measured.
Previous: Why xenon lamp is used in fluorescence spectroscopy?
N e x t : What is the standard for flammability test?
