The operation and installation of the xenon arc weatherometer precautions

Xenon arc weatherometer is a comprehensive climate test device, in addition to climate aging test, but also for high score material light resistance test, that is, polymer materials exposed to artificial light source simulating the spectrum of daylight through the glass to evaluate the material light resistance performance. With the continuous innovation of climate aging chamber technology, the control means are more and more advanced and high-tech, and the control system tends to be more and more precise and standardized, so the operation needs to pay attention to some problems when the control system is more and more precise, and it is very necessary to operate the climate aging chamber according to the correct process. Can avoid the machine because of improper operation and failure, the correct maintenance method can extend the life of the machine.

The good method of xenon aging test chamber test depends on the needs of the test, and each method is very effective. The appropriate test equipment should be selected based on the product or material being tested, the final application conditions, the degradation model and the budget being considered.

 

xenon arc weatherometer operation precautions: xenon arc weatherometer can be exempted from incorrect operation of personnel to produce failure, the correct maintenance can extend the life of the test chamber.

 

1. In the operation, unless it is necessary to open the door of the test chamber, please do not open the door of the equipment, otherwise it will cause adverse consequences.

2. Provide instructions for testing products to protect the safety of the test chamber operator, please check the water pressure controller and water level of the circulating water tank regularly.

3. The test cloth of the wet ball of the test device can ensure the correctness of the relative humidity.

4. Please read this manual in detail before operating the test chamber.

 

xenon arc weatherometer installation matters.

 

1. Installation location should consider heat dissipation and usually easy to check the location of maintenance

2. The distance between the running wall and other machines should have a small distance of more than 600mm.

3. Set up on flat ground without vibration.

4. The ventilation is well chosen and not exposed to direct sunlight.

5. The machine should be far from heat source and flammable and explosive materials.

6. The power supply line and supply and drainage pipe should be shortened as much as possible.

7. Please choose less dust and moisture and pass.

 

For more information about the operation of the xenon arc weatherometer, please leave us a message!