How the Circular track method fuzzing and pilling tester works?

The Circular track method fuzzing and pilling tester is used to test the condition of pilling balloons on woollen, chemical fibre cotton, blended, knitted and woven fabrics in order to identify the quality of the product and the effect of the process. The test is carried out by rubbing the fabric against a nylon brush and abrasive, or against the abrasive only in a damped state.

Circular track method fuzzing and pilling tester test principle.

The fabric is rubbed with nylon brushes or abrasives alone, or with abrasives in a damped state only, to pilling and pilling in accordance with the specified method and experimental parameters, and then the pilled specimen is compared with the sample under the specified lighting conditions to assess the pilling level.

 

Circular track method fuzzing and pilling tester installation 3 elements.

1. Place on a firm bench and place a layer of rubber matting flat on the bench surface to prevent the instrument from sliding during operation.

2. Adjust the foot nuts so that they are level.

3. Check that the power supply voltage meets the requirements of 220V±10% and that the earth wire is connected and introduced into the socket.

 

Circular track method fuzzing and pilling tester test in 5 steps.

1. Set the number of counters according to GB4802.1-97.

2. Take the specimen and clamp it into the specimen holder correctly and firmly.

3. Lower the specimen chuck so that the specimen is in contact with the abrasive plane.

4. Press the "RUN" key to make the instrument do the ball work.

5. After the automatic stop, turn up the specimen chuck and take down the finished specimen for evaluation.